FLUXO 6 - AEROSOL

Inspection :

The part is subjected to an intense magnetic flux, which is deviated by the presence of a defect. This escape attracts the particles of the product and the defects now are clearly visible as fluorescent lines.


Components are magnetised and FLUXO 6 is applied to the test area, normally by spraying immediately prior to and during magnetisation. Application of FLUXO 6 should cease before the magnetisation is switched off. Defects will show up as well defined fluorescent indications and inspection should take place in good UV Light of at least 1500 μW/cm².


Use :

This Magnetic particle examination is used for the detection of emerging defects in all ferromagnetic materials. Applicability: Aeronautics, Automobile, Railway, etc...


Composition :

FLUXO 6: Fluorescent magnetic powder and high flash point petroleum